- Meetings & Activities
- PONY Cruise Schedules
- Featured Articles/Essays
- Harbor Happenings
- PONY Resources
- The Porthole - Newsletter
SPECIAL NOTICE!
- Other NY Maritime websites
- Steamship Historical Society of America
- Additional Worldwide Maritime websites
~ Queen Mary 2 ~
Construction of the Largest Liner in the World
Part Two -
BEGINNING WITH THE FLOAT OUT ~ MARCH 21, 2003 UNTIL THE DELIVERY OF THE PODS - JUNE 6, 2003
Just before dawn QUEEN MARY 2 enters her element for the first time.
(Maurizio Eliseo)
AS the sky brightens QUEEN MARY 2 is afloat for the first time.
(Maurizio Eliseo)
QUEEN MARY 2 in the early morning haze.
(Maurizio Eliseo)
Stephen Payne the proud naval architect of QUEEN MARY 2.
QUEEN MARY 2 newly floated out is berthed at her new location.
QUEEN MARY 2 afloat at her new berth March 25, 2003. Note the progress of the painting of the hull.
(Maurizio Eliseo)
~ THREE PHOTOGRAPHS TAKEN ON APRIL 4, 2003 ~
PHOTOGRAPHER MAURIZIO ELISEO
A view of the upper most part of the funnel. One can see the port tyfon mounted on the side of the funnel casing.
(Maurizio Eliseo)
The new funnel top is lifted onto the liner.
(Maurizio Eliseo)
A fine overall view of QUEEN MARY 2 with her now complete funnel.
(Maurizio Eliseo)
The funnel of QUEEN MARY 2 is "topped-off" and the tyfon horns are installed. (Photograph Ouest-France - April 4, 2003)
One of the tyfons is an almost 70 year old original steam tyfon from QUEEN MARY (1936). Kockums of Sweden, the original manufacturer, built a duplicate and both were installed on the funnel of QM2. Each tyfon horn is six feet, seven inches long and weighs approximately one ton. The enormous sound of these tyfons (the note A - 2 octaves below middle C) will be heard for ten miles.
A closeup of the finished funnel, April 6, 2003.
(Maurizio Eliseo)
A view of tourists visiting the shipyard week-end April 19-20, 2003.
(Ouest-France)
A view of QUEEN MARY 2 taken from ISLAND PRINCESS, May 9, 2003.
(Maurizio Eliseo)
A view of one of the 284 ton Rolls-Royce "Mermaid" propulsion system pods at the shipyard May 20, 2003.
(Ouest-France)
A view of QUEEN MARY 2 once again in the drydock, taken on May 28, 2003.
(Maurizio Eliseo)
A view of the first Rolls-Royce "Mermaid" propulsion system pod being installed on QUEEN MARY 2 June 6, 2003.
(Ouest-France)
Model of QUEEN MARY 2.
QUEEN MARY 2 CUTAWAY